Felt strip: 3/8" thick by 1" and 3/8" by 2" sold by the foot (used on most models)
Dust shield material
Oil Pan gasket (fits 201,218,230ci / 23" head engine)
Oil pressure relief valve spring and gasket fits most all Dodge or Plymouth flat head 6 cylinder engines.
Oil Pressure Valve for Dodge and Plymouth 6 cylinder flat heads engines Option : Check option box for correct size.
Engine Oil "Brad Penn" SAE 30 "BREAK IN" (1qrt.)
Engine Oil "Brad Penn" SAE 30 with zinc (1qrt.) Or SAE "Break In oil"
Check Option box for correct oil.
Zinc Additive (1 pint) mix with oil good for 5-7 qrt. system
Replacement Fuel Filter .
Power Wagon Gas Tank (Stainless steel )(1946-1968) Never have rust again. These are made here at DCM very high quality 304 stainless steel. Requires a 5-hole sender (F-561)
Speedometer gear drive seal ( fits most models specify year)
OD .690 ID .350
Heater Switch Fits all models (6 or 12 volt) Round knob switch is 12 volt.
Shock Mount Stud (lower rear) (qty. 1) fits1939-1947 Dodge and Plymouth Truck
**Buy** S-738-SET and save $
Shock Mount Stud (Set of 4) includes 2 upper studs and 2 lower rear studs fits (1939-1947) Dodge and Plymouth trucks
**Save $4.00 when buy set**
Shock Mount Stud (upper rear)(qty.1) fits 39-53 Dodge and Plymouth truck
**Buy S-738-SET and save $
Tie rod bar included with jam nuts (1939-1947) Dodge and Plymouth Trucks . This is a replacement tie rod bar . It is threaded LH and RH on ends and jam nuts are required but are included with rod.